Chevrolet C&K Pickup (Pre-1999):

1996 GMC Sierra 5.7litre

You are not logged in.

# 1  2/21/2010 6:25 PM

17moss
New member
Registered: 2/21/2010
Posts: 1

1996 GMC Sierra 5.7litre

Problem is that engine was just put in with trans. Only had 40k miles on engine, and engine runs fine until it warms up. Check engine light comes on reads engine misfire #3 cylinder. Changed plugs, wires, rotor and cap, & injector and ECM, and still does it.

Offline

 

# 2  2/21/2010 7:48 PM

Administrator
Administrator
Registered: 9/27/2008
Posts: 1286

Re: 1996 GMC Sierra 5.7litre

What was the trouble code?

Were there any other codes stored in memory?

Do you feel the misfire under any conditions (under load or at idle)?

If it's a confirmed miss under load at #3 determined by a cylinder balance test. Gotta test spark, fuel and compression at that cylinder.


realworldautomotive.com
car and truck information like nowhere else

Offline

 
E-mail Page
Print Page
Save or Share Information
ALLDATAdiy.com is the leading source of factory diagnostic & repair information specific to your car.

Powered by PunBB
Copyright © 2007-  RealWorldAutomotive.com

Save or Share Automotive Information
Custom Search